Bio-rad ProteinChip Data Manager Software Manuel d'utilisateur télécharger pdf (Page 37)

Page 32 Networking the ProteinChip SELDI System

ProteinChip SELDI System: Reader Guide

Fig. 28: The Internet Protocol (TCP/IP) Properties dialog box.

2. Click on Obtain an IP address automatically and click OK.

3. Test the connection. Use a different computer already on your network to

ping the server's hostname (from the command prompt, type ping

followed by the hostname). Be aware that it may take a few minutes for the

DHCP settings to take effect. If the computer receives a reply to the ping,

then the reader settings have been changed correctly. If you cannot ping

the reader hostname, proceed to the Troubleshooting section (page 48).

Redirect Client Computers to the New Server Address

The new server settings must be entered onto each installation of ProteinChip

data manager client software separately.

1. Start the client.

2. In the Login dialog box, click the “…” button. This will open the Servers

dialog box (Fig. 29).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 57 58

Pas de commentaire

Bio-rad ProteinChip Data Manager Software Manuel d'utilisateur Page 37