Bio-rad BioLogic QuadTec™ Detector and Components Manuel d'utilisateur télécharger pdf (Page 13)

2.1 INSTRUMENT CONTROL MODULE (ICM): FOR USE WITH THE DUOFLOW ONLY

The ICM translates the signal from the QuadTec detector and transmits it to the BioLogic DuoFlow

workstation. The ICM contains the following:

Front View

• Address setting: The dial should always be set to position 1

• Instrument bus connector: This connector is for System Cable 17 which connects to the BioLogic

Workstation and the Model 2128 Fraction Collector if used. (Refer to Figure 2-3.)

Rear View

• Serial Comm connector: This connector is for system cable 25 (QuadTec RS232 cable), which

connects to the QuadTec detector

• Power connector: This connector connects to the BioLogic DuoFlow workstation DC outlet with

system cable 26

Figure 2-2.

Instrument Control Module (ICM)

(front and rear views)

USE WITH THE BIOLOGIC DUO-FLOW SYSTEM SYSTEM INSTALLATION AND SETUP

2-2

INSTR. BUS INSTR. BUS

DEVICE

NUMBER

COMM

POWER

9...25 V

0.3A MAX

_ _ _

FRONT VIEW REAR VIEW

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Pas de commentaire

Bio-rad BioLogic QuadTec™ Detector and Components Manuel d'utilisateur Page 13