Cooling ModuleInstructionManualCatalog Numbers170-3654,170-3655, and 170-3688For Technical Service Call Your Local Bio-Rad Office or in the U.S. Call
Section 7Main Switch Fuse Check1) Turn the unit around so that the back of the unit is facing forward, and locate the blackplastic assembly containin
Life ScienceGroupWeb sitewww.bio-rad.com Bio-Rad Laboratories Main OfficeAlso in: AustraliaPh. 02 9914 2800, Fx. 02 9914 2889 AustriaBelgium Ph. 09
WarrantyBio-Rad Laboratories’ Cooling Module is warranted against defects in materials and workmanshipfor 1 year. If any defects occur in the instrume
Table of ContentsPageSection 1 General Information...1Section 2 Spe
Section 1General InformationThe Cooling Module has been specifically designed as a stand alone, portable refrigerat-ed apparatus for use with the CHEF
Section 2SpecificationsCooling Module Chassis aluminumDimensions 42 cm long x 23 cm wide x 24 cm highWeight 14 kgCompressor 1/12 HPRefrigerant CFC 12H
Definition of SymbolsCaution, risk of electric shockCaution (refer to accompanying documents)Note: This equipment has been tested and found to comply
The Cooling Module can now be added to the CHEF buffer circulation system as follows (see figure 2):1) Attach the buffer inflow tube (3/8" tube f
5.3 OperationAfter the Cooling Module has been connected, the following steps should be followed foroptimal operation.1) Switch on the recirculating p
Bio-Rad recommends that the buffer in the system be pre-cooled to the desired run temperature. The Cooling Module can quickly pre-cool the system, at
Commentaires sur ces manuels